Pool Frog Inground Mineral Reservoir

Replacing a Pool Frog Mineral Reservoir, Frog Bam, and Bac Pac:

1. Check Compatibility: Ensure you have the correct Pool Frog Mineral Reservoir for your system (in-ground vs. aboveground).
2. Turn Off Pump: Set the dial to "Pac Removal" or "Setting 0."
3. Prepare Reservoir:
4. Install Frog Bam:
5. Circulate Frog Bam: Turn the pump on for 90 minutes.
6. Remove Frog Bam: Turn off the pump, set the dial to "Pac Removal" or "Setting 0," and remove the cycler cap. Let the water drain before discarding Frog Bam.
7. Install Bac Pac:

Maintenance:

• Mark Calendar: Replace the Pool Frog Mineral Reservoir every 6 months, Frog Bam every 90 days, and the Bac Pac as needed.
• Handle Safely: Avoid sparks, open flames, or smoking when handling the Bac Pac.

Start-Up and Operation:

1. Add Stabilizer: If stabilizer is below 20 ppm, add it to prevent chlorine burn-off.
2. Shock Pool: Use chlorine shock to eliminate contaminants (do not add near the skimmer or cycler).
3. Install Reservoir: Insert the Pool Frog Mineral Reservoir into the cycler, replace the cap, and run on "Maximum" or "Setting 10" for 10 minutes.
4. Add Frog Bam: Insert it into the reservoir in the cycler.
5. Monitor Chlorine: Once chlorine is at 1 ppm, insert the Bac Pac.
6. Set Control Dial: Match the dial setting to your pool’s parameters.
7. Test Water: Test daily for the first week, then weekly throughout the season.
8. Shock Regularly: Shock the pool every two weeks or as needed to maintain water quality.

Silver Chloride:0.5% | Other Ingredients:99.5%