Pool Frog BAM! Algae KNOCK-OUT

Dosage:

Routine Maintenance: 24 fl oz per 15,000 gallons of water every 3 months.

Visible Algae: 44 fl oz per 15,000 gallons of water.

Directions:

1. Maintain the pH of pool water between 7.2-7.8. Adjust to 7.2 for severe algae.
2. Ensure the filtration system is working properly and the cycle is adequate.
3. Brush the pool regularly to help remove stubborn algae.
4. While Frog Bam controls algae, maintain adequate chlorine levels to control bacteria.
5. Do not superchlorinate 48 hours before or after using this product.
6. Avoid adding other chemicals until this product has circulated for at least 24 hours.

Placement:

1. Turn off the circulation pump, set the dial to "Pac Removal" or "Setting 0," and remove the Cycler cap.
2. Remove the cap from Frog Bam (keep the seal intact) and insert it upside down into the Pool Frog Mineral Reservoir, pressing down to puncture the seal.
3. Replace the Cycler cap, set the control dial to "Maximum" or "Setting 10," and turn the pump on for 90 minutes.

Removal:

1. Turn off the pump, set the dial to "Pac Removal" or "Setting 0," and remove the Cycler cap.
2. Lift out Frog Bam and allow any water to drain before discarding. If the water inside the Cycler shows a blue tint, run the pump for one minute on "Maximum" or "Setting 10."
3. Repeat the placement and removal process if additional Frog Bam is required.
4. Insert a Pool Frog Chlorine Bac Pac following the label directions.

Elemental Copper as Triethanolamine Complex: 3.03% | Other Ingredients: 96.97%